How to spot FENDER strat neck replacement using a Squire neck, to deceive?
And a fake Fender decal to pass off the guitar as a real stratocaster?
Hi! I’m not sure why anyone would go to the trouble of switching a Squier by Fender neck onto a MIA, MIM, or MIJ Stratocaster body, especially when you can buy a very inexpensive replacement like a Mighty Mite brand (see http://www.anthillmusic.com/storefrontprofiles/DeluxeSFItemDetail.aspx?sid=1&sfid=155275&c=159800&i=233067348 ). Although the neck pocket width is generally compatible within the various Stratocaster product lines, the thickness of the neck heel will vary somewhat; consequently, you would first look to see if the neck or neck pocket showed any signs of modification. If there is no serial number visible on the headstock or neckplate, this would also raise a red flag. Another check would be the width at the nut; most Fender Stratocasters measure 1.69 inches, whereas some Squiers are a narrower 1.61 inches. Lastly, look carefully at the decal and its application. The graphics should be crisp and clear; if not lacquer-covered, a smooth evenly-spaced outline should be visible around the lettering. Hope some of this helps. Best regards, Dana
May 11th, 2010 at 8:36 pm
Hi! I’m not sure why anyone would go to the trouble of switching a Squier by Fender neck onto a MIA, MIM, or MIJ Stratocaster body, especially when you can buy a very inexpensive replacement like a Mighty Mite brand (see http://www.anthillmusic.com/storefrontprofiles/DeluxeSFItemDetail.aspx?sid=1&sfid=155275&c=159800&i=233067348 ). Although the neck pocket width is generally compatible within the various Stratocaster product lines, the thickness of the neck heel will vary somewhat; consequently, you would first look to see if the neck or neck pocket showed any signs of modification. If there is no serial number visible on the headstock or neckplate, this would also raise a red flag. Another check would be the width at the nut; most Fender Stratocasters measure 1.69 inches, whereas some Squiers are a narrower 1.61 inches. Lastly, look carefully at the decal and its application. The graphics should be crisp and clear; if not lacquer-covered, a smooth evenly-spaced outline should be visible around the lettering. Hope some of this helps. Best regards, Dana
References :
May 11th, 2010 at 9:11 pm
Hmmm,i am not sure..
References :